Freedom Recovery Gear Double Line Pull Winch Kit up to 12k winch

Freedom Recovery Gear  Double Line Pull Winch Kit up t 12k winch

Take the guesswork out of assembling a winch recovery setup with the Freedom Recovery Gear FRG-RDDLP-12K kit. Designed for use with winches rated up to 12,000 lb, this kit includes pulley blocks, line extensions, shackles, a continuous-loop tree saver, and a medium Pro Series gear bag.

As A Bonus a 2" receiver recovery adapter, and Trifold VTV field reverence guide.

The included gear supports controlled winching and compatible pulley-block configurations. The kit’s winch rating is a compatibility guide—not a WLL for the complete system. Always follow the rating of each individual component and the winch manufacturer’s instructions.

12k KIT CONTENTS

- 1 Thompson pulley blocks, each with a soft shackle
- 1 Thompson Block 3:1 Kit
- 1 TuFF-X Pro 7/16-inch × 80-foot winch-line extension — 23,500 lb MBS / 4,700 lb WLL
- 2 3/4-inch screw-pin bow shackles — 4.75-tonne WLL each
- 3 TuFF-X Xtreme 7/16-inch × 11-inch soft shackles — 52,000 lb MBS / 10,400 lb WLL each
- 1 12-foot continuous-loop tree saver — 6,000 lb WLL
- Bonus 2-inch receiver recovery adapter — 10,000 lb WLL
- 1 Medium Pro Series Recovery Gear Bag

10k KIT CONTENTS

- 1 Thompson pulley blocks, each with a soft shackle
- 1 Thompson Block 3:1 Kit
- 1 TuFF-X Pro 3/8-inch × 80-foot winch-line extension — 18,000 lb MBS / 3,600 lb WLL
- 23/4-inch screw-pin bow shackles — 4.75-tonne WLL each
- 3 TuFF-X Xtreme 3/8-inch × 10-inch soft shackles — 41,500 lb MBS / 41,500 lb WLL each
- 1 12-foot continuous-loop tree saver — 6,000 lb WLL
- Bonus 2-inch receiver recovery adapter — 10,000 lb WLL
- 1 Medium Pro Series Recovery Gear Bag

CANADIAN-MADE TUFF-X™ XTREME RECOVERY GEAR

TuFF-X synthetic ropes, extensions, and soft shackles in this kit and pulley are proudly made in Canada. 

MBS AND WLL DEFINITIONS

MBS means Minimum Breaking Strength: the lowest amount of force or load a product or component can withstand during controlled testing before it structurally breaks or fails.

WLL means Working Load Limit: the maximum load specified by the manufacturer for normal use. Do not exceed the marked or published WLL for any component.

SAFETY

- Use this kit for controlled winching only. It is not a kinetic or snatch-recovery kit.
- Use the pulley blocks and 3:1 kit only in configurations approved by the manufacturer. Follow the WLL for each component and configuration.
- The working capacity of the complete system is limited by its lowest-rated component.
- Confirm that the winch, anchor, recovery points, shackles, and connectors are suitable for the load. Never attach recovery gear to a tow ball or an unrated point.
- Inspect ropes, extensions, soft shackles, pulley blocks, shackles, and adapters before each use. Do not use damaged or excessively worn gear.
- Avoid sharp edges and abrasive surfaces. Use suitable abrasion protection where needed.
- Do not knot synthetic rope unless the manufacturer specifically approves the method.
- Perform a controlled, low-load check of the rigging before applying a heavier pull. Stop if any component shifts, binds, or shows signs of damage.
- Keep people clear of the tensioned line, pulley blocks, anchor, and line of pull. Never touch a rope or connector under tension.
- If you are not trained to rig or operate winch recovery equipment, seek instruction from a qualified professional before use.

ADDITIONAL INFORMATION

- Product appearance and colors may vary.
- Warranty coverage may vary by component and manufacturer; see applicable warranty terms.
- Specifications are subject to change without notice.

CALIFORNIA PROPOSITION 65 WARNING

⚠ WARNING: Cancer and Reproductive Harm — www.P65Warnings.ca.gov