YOKE 8-807 High-Strength Alloy Screw-Pin Bow Shackle for 4WD Recovery

YOKE High-Strength Alloy Screw-Pin Bow Shackle – Series 8-807 / Super Alloy / SHG

Add a YOKE Series 8-807 high-strength screw-pin bow shackle to a compatible 4WD recovery setup. The forged alloy-steel body and alloy pin provide a strong, reusable connection for compatible recovery rigging. Select the shackle by its marked Working Load Limit (WLL) and confirm it is suitable for every component in your recovery system.

FEATURES

- YOKE Series 8-807 forged alloy bow shackle with screw pin
- Forged alloy-steel body and alloy pin; quenched and tempered
- 5:1 minimum ultimate load factor
- Proof tested to 2 times the WLL
- Hot-dip galvanized finish
- Size and WLL permanently marked on each shackle
- Traceability code links to product and test documentation
- 100% magnaflux crack detection during manufacturing
- Manufacturer-rated for 20,000 fatigue cycles at 1.5 times the WLL

AVAILABLE SIZES AND RATINGS

- 1/2-inch — YOKE Part No. 8-807-13: 3.3 metric tonnes WLL
- 3/4-inch — YOKE Part No. 8-807-19 / SHG34YOKE: 7.0 metric tonnes WLL
- 7/8-inch — YOKE Part No. 8-807-22 / SHG78YOKE: 9.5 metric tonnes WLL

Ratings and part numbers vary by model. Check the markings on the specific shackle before use.

MBS AND WLL DEFINITIONS

MBS means Minimum Breaking Strength: the lowest amount of force or load a product or component can withstand during controlled laboratory testing before it structurally breaks or fails.

Working Load Limit (WLL) is the maximum safe load that a piece of rigging equipment is designed by the manufacturer to handle during normal use. It is much lower than the force required to make the equipment fail or yield.

SAFETY

- Inspect the shackle, pin, threads, and markings before each use. Do not use damaged, deformed, excessively worn, corroded, or unmarked gear.
- Use only the matching manufacturer-supplied pin. Do not substitute a different pin or modify the shackle.
- Fully seat the screw pin and follow the manufacturer’s instructions for use.
- Keep the load aligned through the shackle. Do not side-load unless the manufacturer permits it and the applicable rating is followed.
- Do not shock load or use for kinetic or snatch recovery.
- Never exceed the shackle’s marked WLL or the rating of any other component in the recovery system.
- If you are not trained to use recovery equipment, seek instruction from a qualified professional before use.

ADDITIONAL INFORMATION

- Finish appearance may vary.
- Specifications are subject to change without notice.

CALIFORNIA PROPOSITION 65 WARNING

⚠ WARNING: Cancer and Reproductive Harm — www.P65Warnings.ca.gov